This allows longer sections to be passed through the forge. There are two doors cut opposite each other at the top of the forge. The burner comes in at the bottom of the forge at a tangent, allowing the flame to burn in a circular flow following the interior of the forge. The first is built on a 15-inch-diameter pipe standing vertically 18 inches high. I would also have you refer to my extensive links section for other sites on the craft. For details on building a forge like the one I use, visit my website and check out the “Bladesmithing” section. A propane forge is relatively inexpensive and simple to construct. Many blade smiths have switched to propane forges. Coal forges are particularly popular with blacksmiths because of the versatility of the fire. There are many plans and designs for building a charcoal forge. Traditionally, charcoal would have been used to forge swords. If you heat a longer section, the blade will bend as you are working on it. Heating more than a 5- or 6-inch section will only cause problems in forging. Interestingly, you do not need a deep, or long, fire to do the hot work on a lengthy sword blade. There are specific tooling requirements to make swords. Each group is dedicated to the study of its craft, each with teachers and individuals intent on mastery. It is not the need for weapons that stimulates this resurgence, but rather a convergence of interests, that of the modern swordsman and the modern blade smith. The time is right for a new age of swords.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |